PRecision Integrated Signal Measurement module
State of the art DSP based instrument
Fully VXI compliant device
Digitally synthesized stimulus
Digital to analog converter design
more flexible than fixed analog circuitry
Digital measurement sampling
Analog to digital converter design
DSP algorithms
Auto-settling
successive approximations
Low noise system environment
-110dB to 100kHz
DSP-based analog measurement system
250 analog test per second throughput
High performance A to D conversion (16 bit A/D)
R, C, L, RC, RL, diode, zener, transistor ß tests standard
High speed, high accuracy proprietary “DSP Bridge mode” for small capacitor, RC tests
High speed Hi-Cap test using DSP stabilization techniques
On-board temperature-stabilized reference with a simple, one-year calibration cycle (15 minutes typical cal time)
Test verification capacitors and resistors to parallel with the DUT component
High power resistors available for fast capacitor discharge up to 100V
Wide operating temperature range 15oC – 35oC, < 80% humidity non-condensing.
128 Nodes per CC2 card assembly
Analog Relay Matrix
Full 6 wire sensing capability
Shielded Traces (SysCap low and consistent)
Socketed Relays
Diagnostics to the Relay
Programmable Drive Levels
Drive Range -4.3V to +4.3V
32 Pin Groups
Programmable Dual Threshold Receive
Input Ranges
-5V to +5V
High V Input Range, -15V to +15V
+/-10 volt threshold programmable
Programmable termination per pin
4.75KW to Vterm (-5V to +5V, programmable |